Netgear M4100-50G Manuel D’Utilisation

Command Syntax

A command is one or more words that might be followed by one or more parameters. 

Parameters can be required or optional values.

Some commands, such as show network or clear vlan, do not require parameters. 
Other commands, such as network parms, require that you supply a value after the 
command. You must type the parameter values in a specific order, and optional parameters 
follow required parameters. The following example describes the network parms 
command syntax: 

 is the command name. 

 and <netmask> are parameters and represent required values that you 

must enter after you type the command keywords.

[gateway] 

is an optional parameter, so you are not required to enter a value in place of 

the parameter.

The New Template User Manual lists each command by the command name and provides a 
brief description of the command. Each command reference also contains the following 
information:

Format shows the command keywords and the required and optional parameters.

Mode identifies the command mode you must be in to access the command.

Default shows the default value, if any, of a configurable setting on the device.

The show commands also contain a description of the information that the command shows.

Command Conventions

In this document, the command name is in bold font. Parameters are in italic font. You 
must replace the parameter name with an appropriate value, which might be a name or 
number. Parameters are order-dependent. 

Supported

Supported

Supported

Supported

network parms <ipaddr> <netmask> [gateway]