RuggedCom RS8000 Manuel D’Utilisation

RuggedSwitch

™ User Guide

Administration Menu

The Administration command provides the menu shown in the following Figure.

Figure 2: Administration Menu

Configure IP Services

The Configure IP Services command provides the ability to change the IP
Address/mask, Gateway address, Inactivity Timeout, Telnet Sessions Allowed,
TFTP Server and SNMP Get Community parameters.

Note:

These parameters are not changed during a factory reload. The following figure shows

the settings as shipped from the factory.

Figure 3: IP Services Configuration Menu

My Switch         Administration                 Admin Access

          Configure IP Services
          Configure System Identification
          Configure Passwords

Configure Time and Date

Configure SNMP Management Stations

CTRL

Z H l

S Sh ll

My Switch         IP Services Configuration           Admin Access

   IP Address Type       Static
   IP Address        192.168.0.1
   Subnet            255.255.255.0
   Gateway
   Inactivity Timeout      5 min
   Telnet Sessions Allowed 8
   TFTP Server      Get Only
   SNMP Get Community      public

<CTRL> Z-Help S-Shell

IP Address Type

This parameter specifies if the IP configuration is static (i.e. configured through
this menu), or dynamically assigned. If dynamic IP configuration is chosen, the IP
Address, Subnet and Gateway fields will become unavailable for editing and will
not be displayed. These values will be loaded via Dynamic Host Configuration
Protocol (DHCP) and may be viewed using the “ipconfig” shell command.

IP Address

This parameter specifies the IP address of the switch.

RuggedCom