3com WX3000 Manuel D’Utilisation
1-37
Configuration Prerequisites
MSTP runs normally on the device.
Configuring BPDU Guard
Configuration procedure
Follow these steps to configure BPDU guard:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable the BPDU guard
function
function
stp bpdu-protection
Required
The BPDU guard function is disabled by default.
The BPDU guard function is disabled by default.
Configuration example
# Enable the BPDU guard function.
<device> system-view
[device] stp bpdu-protection
Configuring Root Guard
Configuration procedure
Follow these steps to configure the root guard function in system view:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable the root guard function
on specified ports
on specified ports
stp interface
interface-list
root-protection
Required
The root guard function is
disabled by default.
The root guard function is
disabled by default.
Follow these steps to enable the root guard function in Ethernet port view:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet port view
Interface
interface-type
interface-number
—
Enable the root guard function
on the current port
on the current port
stp root-protection
Required
The root guard function is
disabled by default.
The root guard function is
disabled by default.
Configuration example
# Enable the root guard function on GigabitEthernet 1/0/1.
1) Perform this configuration in system view
<device> system-view
[device] stp interface GigabitEthernet1/0/1 root-protection