3com WX3000 Manuel D’Utilisation

 

2-2 

Therefore, when you use the NMS to manage the access control engine and the switching engine on 

the same interface, you must first obtain the management IP addresses of the two SNMP agents and 

obtain the link relationship between them, and then you can access the two agents. By default, the 

management IP address of an OAP module is not configured. 

 

Before configuring the management IP address of the OAP software system, you must configure the 

same IP address at the engine side where the OAP software system resides; otherwise, the NMS 

cannot access the OAP software system by using the configured management IP address. 

 

Follow these steps to configure the management IP address of the OAP software system: 

Enter system view 

system-view 

— 

Configure the management IP 
address of an OAP module 

oap management-ip 
ip-address slot 0 

Required 

Not configured by default. 

 

1)  Configure the management IP address of the OAP software system on the switching engine side. 

<device_LSW> system-view 

[device_LSW] interface vlan-interface 1 

[device_LSW-Vlan-interface1] ip address 192.168.0.2 24 

Press Ctrl+K to return to the command line operating interface of the access control engine. 

2)  Configure the management IP address of the SNMP agent on the access control engine. 

<device> system-view 

[device] oap management-ip 192.168.0.2 slot 0 

1)  Configure the management IP address of the OAP software system on the access control engine 

side. 

<device> system-view 

[device] interface Vlan-interface 1 

[device-Vlan-interface1] ip address 192.168.0.1 24 

2)  Log in to the switching engine, and configure the management IP address of the SNMP agent on 

the switching engine. 

<device> oap connect slot 0 

Connected to OAP!  

<device_LSW> system-view 

[device_LSW] oap management-ip 192.168.0.1 slot 0