3com WX3000 Manuel D’Utilisation
1-4
z
You can assign at most two IP address to an interface, among which one is the primary IP address
and another is secondary IP addresses. A newly specified primary IP address overwrites the
previous one if there is any.
z
The primary and secondary IP addresses of an interface cannot reside on the same network
segment; the IP address of a VLAN interface must not be on the same network segment as that of
a loopback interface on a device.
z
A VLAN interface cannot be configured with a secondary IP address if the interface has been
configured to obtain an IP address through BOOTP or DHCP.
Displaying and Maintaining IP Addressing
To do…
Use the command…
Remarks
Display information about a specified
or all Layer 3 interfaces
or all Layer 3 interfaces
display ip interface [ interface-type
interface-number ]
interface-number ]
Display brief configuration information
about a specified or all Layer 3
interfaces
about a specified or all Layer 3
interfaces
display ip interface brief
[ interface-type [ interface-number ] ]
[ interface-type [ interface-number ] ]
Available in any
view
view
IP Address Configuration Examples
IP Address Configuration Example I
Network requirement
As shown in
, assign IP address 129.2.2.1 with mask 255.255.255.0 to VLAN-interface 1 of
Switch.
Figure 1-3 Network diagram for IP address configuration
PC
Switch
Console Cable
Configuration procedure
# Configure an IP address for VLAN-interface 1.
<device> system-view
[device] interface vlan-interface 1
[device-Vlan-interface1] ip address 129.2.2.1 255.255.255.0