3com WX3000 Manuel D’Utilisation

 

3-11 

[device-ui-vty0] protocol inbound telnet 

# Set the maximum number of lines the screen can contain to 30. 

[device-ui-vty0] screen-length 30 

# Set the maximum number of commands the history command buffer can store to 20. 

[device-ui-vty0] history-command max-size 20 

# Set the timeout time to 6 minutes. 

[device-ui-vty0] idle-timeout 6 

1)  Assign an IP address to VLAN-interface 1 of the access control engine of the device (VLAN 1 is the 

default VLAN of the access control engine). 

z 

Connect the serial port of your PC/terminal to the console port of the device, as shown in 

. 

Figure 3-4 Diagram for establishing connection to a console port 

 

 

z 

Launch a terminal emulation utility (such as Terminal in Windows 3.X or HyperTerminal in 

Windows 95/Windows 98/Windows NT/Windows 2000/Windows XP) on the PC terminal, with the 

baud rate set to 9,600 bps, data bits set to 8, parity check set to none, and flow control set to none. 

z 

Power on the device and press Enter as prompted. The prompt (such as <device>) appears, as 

shown in the following figure. 

Figure 3-5 The terminal window