3com WX3000 Manuel D’Utilisation

 

1-24 

Follow these steps to redirect packets that are of a VLAN and match specific ACL rules: 

Enter system view 

system-view 

— 

Configure traffic redirecting 

traffic-redirect vlan vlan-id inbound acl-rule 
interface interface-type interface-number 

Required 

 

Follow these steps to redirect packets that are of a port group and match specific ACL rules: 

Enter system view 

system-view 

— 

Enter port group view 

port-group group-id 

— 

Configure traffic redirecting 

traffic-redirect inbound acl-rule interface 
interface-type interface-number 

Required 

 

Follow these steps to redirect packets passing a port and matching specific ACL rules: 

Enter system view 

system-view 

— 

Enter Ethernet port view 

interface interface-type interface-number 

— 

Configure traffic redirecting 

traffic-redirect inbound acl-rule interface 
interface-type interface-number 

Required 

 

If the traffic is redirected to a Combo port in down state, the system automatically redirects the traffic to 

the port corresponding to the Combo port in up state. Refer to the Port Basic Configuration module of 

this manual for information about Combo ports.  

 

As the priority of traffic classification rules is higher than that of the default rules used for processing 

protocol packets, redirecting all the packets or packets of a VLAN may affect device management that 

is implemented through Telnet and so on. 

 

z 

GigabitEthernet 1/0/1 belongs to VLAN 2 and is connected to the 10.1.1.0/24 network segment. 

z 

Redirect all the packets from the 10.1.1.0/24 network segment to GigabitEthernet 1/0/7. 

1) Method 

I 

<device> system-view 

[device] acl number 2000 

[device-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255