3com WX3000 Manuel D’Utilisation
1-3
MIB attribute
MIB content
Related RFC
DHCP MIB
QACL MIB
MSTP MIB
VLAN MIB
IPV6 ADDRESS MIB
MIRRORGROUP MIB
QINQ MIB
802.x MIB
HGMP MIB
NTP MIB
Device management
Private MIB
Interface management
—
Configuring Basic SNMP Functions
Because the configuration of SNMPv3 is quite different from that of SNMPv1 and SNMPv2c, their
configuration procedures are described in two subsections.
Configuring basic SNMP functions for SNMPv1 or SNMPv2c
Follow these steps to configure basic SNMP functions for SNMPv1 or SNMPv2c:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable SNMP agent
snmp-agent
Optional
Disabled by default.
You can enable SNMP
agent by executing this
command or any of the
commands used to
configure SNMP agent.
agent by executing this
command or any of the
commands used to
configure SNMP agent.
Set system information, and specify
to enable SNMPv1 or SNMPv2c on
the device
to enable SNMPv1 or SNMPv2c on
the device
snmp-agent sys-info
{ contact sys-contact |
location sys-location |
version { { v1 | v2c | v3 }* |
all } }
{ contact sys-contact |
location sys-location |
version { { v1 | v2c | v3 }* |
all } }
Required
By default, the contact
information for system
maintenance is "3Com
Corporation.", the system
location is "Marlborough,
MA 01752 USA", and the
SNMP version is None.
information for system
maintenance is "3Com
Corporation.", the system
location is "Marlborough,
MA 01752 USA", and the
SNMP version is None.