3com WX3000 Manuel D’Utilisation

 

1-16 

[12345]1.0.1.11    127.127.1.0     2    1   64    1   350.1   15.1    0.0 

note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured Total 

associations :  1   

z 

As shown in 

, the local clock of Device A is set as the NTP master clock, with the clock 

stratum level of 2. 

z 

Device C (a WX3000 series device) uses Device A as the NTP server, and Device A works in 

server mode automatically.  

z 

The local clock of Device B is set as the NTP master clock, with the clock stratum level of 1. Set 

Device C as the peer of Device B. 

Figure 1-7 Network diagram for NTP peer mode configuration 

Device A

Device B

Device C

3.0 .1.31/24

3.0.1.32/24

3 .0.1.33/24

 

 

1)  Configure Device C. 

# Set Device A as the NTP server. 

<DeviceC> system-view 

[DeviceC] ntp-service unicast-server 3.0.1.31 

2)  Configure Device B (after the Device C is synchronized to Device A). 

# Enter system view. 

<DeviceB> system-view 

# Set Device C as the peer of Device B. 

[DeviceB] ntp-service unicast-peer 3.0.1.33 

Device C and Device B are symmetric peers after the above configuration. Device B works in symmetric 

active mode, while Device C works in symmetric passive mode. Because the stratum level of the local 

clock of Device B is 1, and that of Device C is 3, the clock of Device C is synchronized to that of Device 

B. 

View the status of Device C after the clock synchronization. 

[DeviceC] display ntp-service status 

 Clock status: synchronized 

 Clock stratum: 2