Manualsbrain.com
  1. Manuels
  2. Marques
  3. 3com
  4. WX3000
  5. Manuel D’Utilisation

3com WX3000 Manuel D’Utilisation

Télécharger
Page de 715
 
2-6 
Figure 2-3 Network diagram for Monitor Link configuration 
BLOCK
Switch A
Switch B
GE1 /0/1
GE1/0 /2
Switch C
Switch D
Switch E
GE1/0 /1
GE1/0 /2
GE1 /0/3
Server
GE 1/0/2
GE 1/0/2
GE 1/0/1
GE1 /0/1
GE1 /0/3
GE 1/0/11
GE1/0/10
PC 1
PC 4
PC 3
PC 2
 
 
Configuration procedure 
1)  Enable Smart Link on Switch A and Switch B to implement link redundancy backup. Perform the 
following configuration on Switch A. The configuration on Switch B is the same as on Switch A. 
# Enter system view.  
<switchA> system-view 
# Enter Ethernet port view. Disable STP on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. 
[SwitchA] interface GigabitEthernet 1/0/1 
[SwitchA-GigabitEthernet1/0/1] stp disable 
[SwitchA-GigabitEthernet1/0/1] quit 
[SwitchA] interface GigabitEthernet 1/0/2 
[SwitchA-GigabitEthernet1/0/2] stp disable 
# Return to system view. 
[SwitchA-GigabitEthernet1/0/2] quit 
# Create Smart Link group 1 and enter Smart Link group view. 
[SwitchA] smart-link group 1 
# Configure GigabitEthernet 1/0/1 as the master port of the Smart Link group and GigabitEthernet 1/0/2 
as the slave port.  
[SwitchA-smlk-group1] port GigabitEthernet 1/0/1 master 
[SwitchA-smlk-group1] port GigabitEthernet 1/0/2 slave 
# Configure to send flush messages in VLAN 1. 
[SwitchA-smlk-group1] flush enable control-vlan 1