3com WX3000 Manuel D’Utilisation

 

2-3 

As shown in 

, Switch A supports PoE. 

GigabitEthernet 1/0/1 through GigabitEthernet 1/0/10 of Switch A are used by users of group A, who 

have the following requirements: 

z 

The PoE function can be enabled on all ports in use. 

z 

Signal mode is used to supply power. 

z 

The PoE priority for GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5 is Critical, whereas the 

PoE priority for GigabitEthernet 1/0/6 through GigabitEthernet 1/0/10 is High. 

z 

The maximum power for GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5 ports is 3,000 mW, 

whereas the maximum power for GigabitEthernet 1/0/6 through GigabitEthernet 1/0/10 is 15,400 

mW. 

Based on the above requirements, two PoE profiles are made for users of group A. 

z 

Apply PoE profile 1 for GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5; 

z 

Apply PoE profile 2 for GigabitEthernet 1/0/6 through GigabitEthernet 1/0/10. 

Figure 2-1 PoE profile application 

Network

IP Pone

Switch A

AP

IP Pone

IP Pone

IP Pone

AP

AP

AP

GE1/0/1~GE 1/0/5

GE 1/0/6 ~GE 1/0 /10

 

 

# Create Profile1, and enter PoE profile view. 

<SwitchA> system-view 

[SwitchA] poe-profile Profile1 

# In Profile1, add the PoE policy configuration applicable to GigabitEthernet 1/0/1 through 

GigabitEthernet 1/0/5 ports for users of group A.