3com WX3000 Manuel D’Utilisation

 

1-9 

Display the information about ports on 
which voice VLAN configuration fails 

Display the voice VLAN configuration 
status 

Display the currently valid OUI addresses

Display the ports operating in the current 
voice VLAN 

display vlan vlan-id 

You can execute the 
display command in 
any view. 

 

Create a voice VLAN and configure it to operate in automatic mode to enable the port to which an IP 

phone is connected to join or exit the voice VLAN automatically and voice traffic to be transmitted within 

the voice VLAN, as shown in 

. 

z 

Create VLAN 2 and configure it as a voice VLAN, with the aging time being 100 minutes. 

z 

The IP phone sends tagged packets. It is connected to GigabitEthernet 1/0/1, a hybrid port, with 

VLAN 6 being its default VLAN. Set this port to operate in automatic mode. 

z 

You need to add a user-defined OUI address 0011-2200-000, with the mask being ffff-ff00-0000 

and the description string being “test”.  

Figure 1-2 Network diagram for voice VLAN configuration (automatic mode) 

Internet

Device A

GEth1/0/1

VLAN2

VLAN 2

010- 1001
OUI: 0011- 2200- 0000
Mask:ffff-ff00- 0000

Device B

 

 

# Create VLAN 2 and VLAN 6. 

<DeviceA> system-view 

[DeviceA] vlan 2 

[DeviceA-vlan2] quit 

[DeviceA] vlan 6 

[DeviceA-vlan6] quit 

# Set the aging time for the voice VLAN.