3com 4500 26-PORT Manuel D’Utilisation
118
C
HAPTER
5: U
SING
N
ETWORK
P
ROTOCOL
C
OMMANDS
other ports of this group, that is, Layer 2 forwarding between the isolated ports is
not available.
not available.
Use the
undo port isolate
command to remove a port from an isolation group.
By default, a port is not in an isolation group, namely Layer 2 forwarding is
achievable between this port and other ports.
achievable between this port and other ports.
Example
To add Ethernet1/0/1 and Ethernet1/0/2 to isolation group, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]interface ethernet 1/0/1
[4500-Ethernet1/0/1]port isolate
[4500-Ethernet1/0/1]quit
[4500]interface ethernet 1/0/2
[4500-Ethernet1/0/2]port isolate
UDP Helper
Configuration
Commands
Configuration
Commands
This section describes the commands you can use to configure and manage the
UDP Helper Configuration operations on your Switch 4500.
UDP Helper Configuration operations on your Switch 4500.
debugging udp-helper
Syntax
debugging udp-helper { event | packet [ receive | send ] }
undo debugging udp-helper { event | packet [ receive | send ] }
View
User view
Parameters
event
UDP Helper event debugging.
packet
UDP Helper packet debugging.
receive
UDP Helper inbound packet debugging.
send
UDP Helper outbound packet debugging.
Description
Use the
debugging udp-helper
command to enable UDP Helper debugging.
Use the
undo debugging udp-helper
command to disable UDP Helper
debugging.
By default, UDP Helper debugging is disabled.
Example
To enable UDP Helper packet debugging, enter the following:
<4500>debugging udp-helper packet