3com 4500 26-PORT Manuel D’Utilisation

 Configuration: Transmit Period 30 s,  Handshake Period 15 s

Quiet Period 60 s,  Quiet Period Timer is disabled

Supp Timeout 30 s,  Server Timeout 100 s

The Max-Req 3

 Total maximum 802.1x user resource number is 1024

 Total current used 802.1x resource number is 0

 Ethernet1/0/1 is link-up

   802.1X protocol is disabled

   Proxy trap checker is disabled

   Proxy logoff checker is disabled

   The port is a(n) authenticator

   Authentication Mode is Auto

   Port Control Type is Mac-based

   Max number of on-line users is 256

… (Omitted)

dot1x [ interface interface-list ]

undo dot1x [ interface interface-list ]

Ethernet Port View

 Ethernet port list including several Ethernet ports. 

interface-list = { interface-num [ to interface-num ] } & < 1-10 >. 

 specifies a single Ethernet port in the format 

interface-num = { 

interface-type interface-num | interface-name }

, where

 

specifies the port type, 

 specifies the port number and 

 specifies the port name. For the respective meanings and value 

ranges, read the Parameter of the Port Configuration section. 

Use the 

 command to enable 802.1x on the specified port or globally, (that is 

on the current device). Use the 

 command to disable the 802.1x on 

the specified port or globally. 

By default, 802.1x is disabled on all the ports and globally on the device.

This command is used to enable the 802.1x on the current device or on the 
specified port. When it is used in System View, if the parameter

 is not 

specified, 802.1x will be globally enabled. If the parameter 

 is 

specified, 802.1x will be enabled on the specified port. When this command is 
used in Ethernet Port View, the parameter interface-list cannot be entered and 
802.1x can only be enabled on the current port. 

The configuration command can be used to configure the global or port 802.1x 
performance parameters before or after 802.1x is enabled. Before 802.1x is