3com 4500 26-PORT Manuel D’Utilisation

C

HAPTER

 1: U

SING

 S

YSTEM

 A

CCESS

 C

OMMANDS

 Sets the stop bits to 1.

Sets the stop bits to 1.5.

 Sets the stop bits to 2.

Use the 

 command to configure the stop bits on the AUX (Console) port. 

Use the 

 command to restore the default stop bits (the default 

 

is 1). 

To configure the stop bits to 2, enter the following from the AUX (Console) port:

<4500>system-view

System View: return to User View with Ctrl+Z.

[4500]user-interface aux 0

[4500-ui-aux0]stopbits 2

All views

Enter a user level in the range 0 to 3. The default is 3.

The 

 command gives a user access to a higher level than their currently 

assigned user level. 

To ensure that only an authorized user can access the higher level, use the 

 command to set a password for the higher level. If the user does not 

enter a valid password, the user level does not change.

Login users are classified into four levels that correspond to the four command 
levels. A user can only use commands at the levels that are equal to or lower than 
their user level.

Related commands: 

, 

.

To change to user level 3 from the current user level.

<4500>super 3

Password:

The password prompt displays only if you set a password using the 

 command.