3com 3CR17662-91 Manuel D’Utilisation
76
A
PPENDIX
A: S
AFETY
I
NFORMATION
urządzenia należy uważnie przeczytać poniższe informacje o
bezpieczeństwie.
bezpieczeństwie.
Power Cord Set—Japan
Important Safety Information
WARNING: Installation and removal of the unit must be carried out by
qualified personnel only.
qualified personnel only.
WARNING: If installing the Switch 4200G together (one on top of the
other) with SuperStack II or SuperStack 3 units that are shallower than
the 4200G, the Switch 4200G unit must be installed below the shallower
units.
other) with SuperStack II or SuperStack 3 units that are shallower than
the 4200G, the Switch 4200G unit must be installed below the shallower
units.
WARNING: The unit must be earthed (grounded) or must be connected
to an earthed power supply to ensure compliance with safety standards.
to an earthed power supply to ensure compliance with safety standards.
WARNING: Power Cord Set:
This must be approved for the country where it is used:
This must be approved for the country where it is used:
U.S.A. and
Canada
Canada
■
The cord set must be UL-approved and CSA certified.
■
The minimum specification for the flexible cord is:
No. 18 AWG
Type SV or SJ
3-conductor
No. 18 AWG
Type SV or SJ
3-conductor
■
The cord set must have a rated current capacity of at least
10A.
10A.
■
The attachment plug must be an earth-grounding type
with a NEMA 5-15P (15A, 125V) or NEMA 6-15P (15A,
250V) configuration.
with a NEMA 5-15P (15A, 125V) or NEMA 6-15P (15A,
250V) configuration.
United
Kingdom only
Kingdom only
■
The supply plug must comply with BS1363 (3-pin 13 amp)
and be fitted with a 5A fuse which complies with BS1362.
and be fitted with a 5A fuse which complies with BS1362.
■
The mains cord must be <HAR> or <BASEC> marked and
be of type H03VVF3GO.75 (minimum).
be of type H03VVF3GO.75 (minimum).
10014914AA.book Page 76 Friday, July 7, 2006 2:08 PM