Enterasys Networks CSX6000 Mode D'Emploi
USER’S GUIDE
180 CyberSWITCH
4.
You may specify an authentication database location for administrative sessions that is
different from the user authentication database location.
different from the user authentication database location.
Note:
If you select RADIUS, TACACS, or ACE, you must be sure that the selected server is
active before you initiate an administrative session.
active before you initiate an administrative session.
5.
From the Administrative Session menu select (2) Session Inactivity Timeout. The following
prompt is displayed:
prompt is displayed:
6.
Follow the onscreen instructions to set the session inactivity timeout session.
7.
From the Administrative Session menu, select (3) Number of Admin Telnet Sessions. The
following prompt is displayed:
following prompt is displayed:
8.
Follow the onscreen instructions to configure the number of administrative Telnet sessions you
wish to allow. Up to three sessions are possible.
wish to allow. Up to three sessions are possible.
Note:
To have any Telnet sessions, you must first enable IP.
9.
To change the value of the port number, select (4) Telnet Server TCP Port Number from the from
the Administrative Session menu.
the Administrative Session menu.
10. Follow the onscreen instructions for entering the port number.
11. Select option (5) Emergency Telnet Server Port Number from the Administrative Session menu.
12. Follow the onscreen prompts to configure the port number.
U
SING
M
ANAGE
M
ODE
admlogin
Displays the current administration session configuration.
admlogin change
Displays the Administration Session Configuration Menu screen, allowing you to change the
authentication database location. Refer to
authentication database location. Refer to
for configuration instructions.
A
DMINISTRATIVE
S
ESSION
C
ONFIGURATION
E
LEMENTS
D
ATABASE
L
OCATION
The authentication database location for administration sessions. This database location may be
different from the user authentication database. The default database location is the on-node device
database.
different from the user authentication database. The default database location is the on-node device
database.
Enter the Session Inactivity Timeout value in minutes.
Use "0" to disable the Session Inactivity Timeout [default = disabled]?
Use "0" to disable the Session Inactivity Timeout [default = disabled]?
Enter the number of Telnet allowed for administrative sessions.
Use "0" to disable the Telnet Server [default = 3]? 1
Use "0" to disable the Telnet Server [default = 3]? 1