Extreme networks 12804 Manuel D’Utilisation
Installing the BlackDiamond 12800 Series Chassis
BlackDiamond 12800 Series Switches Hardware Installation Guide
70
Initial Management Access
After your switch has completed all power on self-tests, it is operational. You can log in and configure
an IP address for the default VLAN (named default).
an IP address for the default VLAN (named default).
NOTE
In BlackDiamond switches, the management port on the MSM is part of the management VLAN by default. Refer to
for further details.
Connecting Equipment to the Console Port
Connection to the console port is used for direct local management. The console port settings are:
●
Baud rate—9600
●
Data bits—8
●
Stop bit—1
●
Parity—None
●
Flow control—XON/XOFF
The terminal or PC with terminal-emulation software that you connect to an Extreme Networks switch
must be configured with these settings. This procedure is described in the documentation supplied with
the terminal.
must be configured with these settings. This procedure is described in the documentation supplied with
the terminal.
Appropriate cables are available from your local supplier, or you can make your own. To ensure the
electromagnetic compatibility of the unit, use only shielded serial cables. For information about the DB-
9 console plug connector, see
electromagnetic compatibility of the unit, use only shielded serial cables. For information about the DB-
9 console plug connector, see