Sony 9000 Manuel D’Utilisation
335
Basic Procedure for DME Wipe Settings
Ch
apt
apt
er 6
DME Wipe
s
4
Set the parameters according to the selection in step
3
.
• When border is selected
• When soft border is selected
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
Setting the DME wipe position (Positioner)
Use the following procedure.
1
In the M/E-1>DME Wipe menu, select HF5 ‘Modify.’
The Modify menu appears.
2
Depending on whether the DME wipe pattern is in one-channel mode or
two-channel mode, proceed as follows.
two-channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
the same time.
Knob
Parameter
Adjustment
Setting values
1
Width
Border width
0.00 to 100.00
3
Luminance
Luminance
0.00 to 100.00
4
Saturation
Saturation
0.00 to 100.00
5
Hue
Hue
359.99 to 0.00
Knob
Parameter
Adjustment
Setting values
1
Width
Border width
0.00 to 100.00
2
Inner Soft
Border inner softness
0.00 to 100.00
3
Luminance
Luminance
0.00 to 100.00
4
Saturation
Saturation
0.00 to 100.00
5
Hue
Hue
359.99 to 0.00