Sony 9000 Manuel D’Utilisation
Chapt
er
10
Mis
c
Men
u
, Et
c
c
.
376
Misc Menu Operations
Misc Menu Operations
In the Misc menu, you can carry out the following operations.
• Enable (on) or disable (off) control from external devices for each port of the
• Enable (on) or disable (off) control from external devices for each port of the
switcher and DME.
• Switch the safe title function on or off for each output.
Enabling or disabling control from an external device
Use the following procedure.
1
In the menu control block, press the top menu selection button [Misc], then
select VF1 ‘Enable’ and HF1 ‘Port Enable.’
select VF1 ‘Enable’ and HF1 ‘Port Enable.’
The Misc>Enable>Port Enable menu appears with the status area showing
the settings of the following ports.
• Switcher Remote 1 to Remote 4 ports (RS-422A, D-sub 9-pin)
• Switcher GPI port (parallel, 25-pin)
• DME1/DME2 Editor ports (RS-422A, D-sub 9-pin)
• DME1/DME2 GPI ports (parallel, 25-pin)
the settings of the following ports.
• Switcher Remote 1 to Remote 4 ports (RS-422A, D-sub 9-pin)
• Switcher GPI port (parallel, 25-pin)
• DME1/DME2 Editor ports (RS-422A, D-sub 9-pin)
• DME1/DME2 GPI ports (parallel, 25-pin)
2
In the <Switcher> or <DME> group, press on the name of the port for
which you want to disable control from an external device, turning it off.
To re-enable control for the port, press on its name once more.
which you want to disable control from an external device, turning it off.
To re-enable control for the port, press on its name once more.
Notes
• It is not necessary to make any settings for DME2.
• For the AUX bus operation from the Remote1 to Remote4 ports of the
• For the AUX bus operation from the Remote1 to Remote4 ports of the
switcher, the setting (Enable/Disable/Manual) in the Setup menu takes
precedence. Only when the setting is “Manual,” the settings made in the
Port Enable menu apply. For details, see “Interfacing With External
Devices (Device Interface Menu)” under “Setup Relating to Switcher
Processor” in Chapter 16 (Volume 2).
precedence. Only when the setting is “Manual,” the settings made in the
Port Enable menu apply. For details, see “Interfacing With External
Devices (Device Interface Menu)” under “Setup Relating to Switcher
Processor” in Chapter 16 (Volume 2).
Switching the safe title function on or off
Use the following procedure.
1
In the menu control block, press the top menu selection button [Misc] and
select VF2 ‘Safe Title.’
select VF2 ‘Safe Title.’
The Misc>Safe Title menu appears.