Avaya 580 Manuel D’Utilisation

7-2

User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1

Chapter 7

In STP, a port that is blocking must change to listening and then learning 
before it can change to forwarding. Normally, a port remains in the listening 
state for 15 seconds and in the learning state for 15 seconds. With these two 
15-second delays, a port normally takes 30 seconds to change from 
blocking to forwarding. This 30-second transition time results in a 30-
second loss of traffic, which is not acceptable in many of today’s networks. 

STP has four different port states: listening, learning, blocking, forwarding, 
and disabled. RSTP has combined three of these states— listening, 
blocking, and disabled—into a single port state: discarding. 

RSTP is completely interoperable with STP. Switches running RSTP and 
switches running STP can be on the same network and work together to 
detect and break loops in the network. 

Interoperability is achieved by the ability of RSTP to detect the presence of 
bridges running STP and to operate in common-spanning-tree mode. When 
an RSTP bridge is connected to an STP bridge and receives STP bridge 
protocol data units (BPDUs), the RSTP bridge sends only STP BPDUs out 
the port that is connected to the STP bridge. If a bridge running STP 
receives RSTP BPDUs, the STP bridge drops the RSTP BPDUs. 

You can also manually set the P580 or P882 to run common Spanning Tree. 

To ensure that your network is not disrupted when you upgrade the switch 
from v5.x application software to v6.0 or later, RSTP has the following 
settings: 

■

The default setting for Spanning Tree version is common Spanning 
Tree.

■

Switch ports for which fast start was enabled are set as edge ports. 
In v6.0 and later, the fast start feature is replaced with the ability to 
set switch ports as edge ports. For information on setting switch 
ports as edge ports, see “

” later in this chapter. 

■

All settings for port priorities and path costs are preserved.