Avaya ELAT Manuel D’Utilisation

ExpertNet Lite Assessment Tool - User Guide

RTP tests offer more complex settings than ping tests and it maybe worthwhile having 
multiple tests to the same endpoint with different settings to see whether there is an 
impact on the metrics gathered. See “Troubleshooting” on page 35 for more 
information about RTP tests.

The following is an example displays two ping tests with different settings. As you 
can see only the first 6 columns contain data. QoS data can only be gathered using 
RTP tests.

The columns in the Network Path View window are as follows:

The endpoint the test is against, typically an edge PC. The icon 

indicates the type of test. The phone icon represents an RTP test 

and the computer icon represents a ping test.

Shows more precisely the type of tests. For RTP tests, this can 

say G.711 or G.729, representing the different codecs. For ping 

tests, this will be ICMP or UDP.

Indicates the last known state of a test. RTP tests can go into the 

OK, Failed and Timeout categories.

-

OK - The endpoint responded successfully. 

-

Not Pingable - The endpoint is not pingable. 

-

Timeout - A ping request was sent, but a response was 
not received.

-

Off Path - A ping response was received from a device 
not located on the tracerouted path.

-

Failed – No results returned for the RTP test

Indicates whether traceroute is enabled or disabled for a path. 

Will be automatically off if the test is in the same subnet.

Displays whether there is a router/switch in the path which can 

be contacted using SNMP.

-

OK - SNMP status was successfully obtained.

-

Not Contactable - The device cannot be contacted.

-

Not Supported - The device does not support SNMP 
queries, or the SNMP Polling option has been deselected..

-

Timeout - The device did not respond to an SNMP query 
in time.