Avaya C460 Manuel D’Utilisation
Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide
67
Example:
network (RIP)
User level: read-write, admin.
L You can only access this command in router-RIP mode.
L You can only access this command in router-RIP mode.
Type router rip at the command prompt to enter router-RIP mode if
necessary.
necessary.
Use the network command to specify a list of networks on which the RIP is
running.
Use the no network command to remove an entry.
running.
Use the no network command to remove an entry.
The syntax for this command is:
[no] network
<ip-address> [<wildcard-mask>]
Example:
To specify that RIP will be used on all interfaces connected to the network
192.168.37.0:
To specify that RIP will be used on all interfaces connected to the network
192.168.37.0:
network (OSPF)
User level: read-write, admin.
L You can only access this command in Router-OSPF mode.
L You can only access this command in Router-OSPF mode.
Type router ospf at the command prompt to enter Router -OSPF mode if
necessary.
necessary.
Use the network command to enable OSPF in this network.
Use the no network command to disable OSPF in this network.
The default is disabled.
Use the no network command to disable OSPF in this network.
The default is disabled.
C460-1(super)# line 5 “C460 CLI”
Done!
ip addr
The IP address of the network of directly connected networks
wildcard-mask
Wildcard mask address. Exists for compatibility with P550.
Router-1 (configure router:rip) # network 192.168.37.0
Done!