Avaya P332MF Manuel D’Utilisation

Chapter 6

CLI – Layer 2

Avaya P332MF User’s Guide

101

Use the

 set port speed 

command to configure the speed of a 10/100Base-T 

port. If autonegotiation mode is enabled for such ports, the port's speed is 
determined by autonegotiation, and an error message is thus generated if you 
attempt to perform the 

set port speed 

command in this case.

This command does not apply to P332G-ML and P332GT-ML ports. An error 

message is generated if you attempt to perform the 

set port speed 

command 

for P332G-ML and P332GT-ML ports. 

The syntax for this command is:

set port speed <mod_num>/<port_num> {value}

Output Example:
To configure port 2 on module 2 port speed to 10 Mbps:

P330-N# set port speed 2/2 10MB

Port 2/2 speed set to 10 Mbps.

Use the

 set port duplex 

command to configure the duplex mode of a 

10/100Base-T port. You can configure the duplex mode to either Half or Full 
duplex. If autonegotiation mode is enabled for such ports, the port’s duplex mode is 
determined by autonegotiation, and an error message is thus generated if you 
attempt to perform the 

set port duplex

  command in this case.

P332G-ML and P332GT-ML switch ports work in Full duplex mode only. An 

error message is generated if you attempt to change P332G-ML and P332GT-ML 
ports to 

half-duplex

.

The syntax for this command is:

set port duplex <mod_num>/<port_num> {full|half}

Example:
To set port 1 on module 2 to full duplex:

P330-N# set port duplex 2/1 full

Port 2/1 set to full-duplex.