Avaya P332MF Manuel D’Utilisation
Avaya P332MF User’s Guide
39
Chapter 6
CLI – Layer 2
This chapter provides all the Layer 2 CLI commands, parameters and their default
values.
The CLI is command-line driven and does not have any menus. To activate a
configuration option, you must type the desired command at the prompt and press
Enter
values.
The CLI is command-line driven and does not have any menus. To activate a
configuration option, you must type the desired command at the prompt and press
Enter
.
Note:
The terms “module” and “switch” are used interchangeably.
User Level Commands
This section describes all commands that are available from the User level.
Following is a table of the User Level commands and command groups (all
commands are also available at the higher levels).
Following is a table of the User Level commands and command groups (all
commands are also available at the higher levels).
• session
Opens a session to another P330 switch, X330
ATM Access sub-module, X330 WAN Access
sub-module or G700 MGP.
ATM Access sub-module, X330 WAN Access
sub-module or G700 MGP.
Page 40
• terminal width
Displays or sets the width of the terminal
display.
display.
Page 40
• terminal length
Display or set the length of the terminal
display.
display.
Page 40
• clear screen
Clears the current terminal display.
Page 41
•
show
1
1 This command corresponds to a group of commands and is shown in a
separate Table on Page 42.
separate Table on Page 42.
Shows the current switch parameters.
Page 42
• ping
Sends ICMP echo request packets to another
node on the network.
node on the network.
Page 41
• dir
Show files in the system.