Avaya P130 Manuel D’Utilisation
Chapter 6 Avaya P130 CLI
Avaya P130 User’s Guide
111
Requested # of time intervals, ie buckets, is 20
Granted # of time intervals, ie buckets, is 20
Sample # 1 began measuring at 2:53:9
Received 62545 octets, 642 packets,
391 broadcast and 145 multicast packets,
0 undersize and 0 oversize packets,
0 fragments and 0 jabbers,
0 CRC alignment errors and 0 collisions,
# of dropped packet events (due to a lack of resources): 0
Network utilization is estimated at 0
Granted # of time intervals, ie buckets, is 20
Sample # 1 began measuring at 2:53:9
Received 62545 octets, 642 packets,
391 broadcast and 145 multicast packets,
0 undersize and 0 oversize packets,
0 fragments and 0 jabbers,
0 CRC alignment errors and 0 collisions,
# of dropped packet events (due to a lack of resources): 0
Network utilization is estimated at 0
Show rmon alarm Command
Use the
show rmon alarm command to show the parameters set for a specific
alarm entry that was set using the
rmon alarm command or using the P130
Device Manager.
The syntax for this command is:
show rmon alarm [<Alarm Index>]
show rmon alarm [<Alarm Index>]
Example:
P130-N> show rmon alarm 1026
P130-N> show rmon alarm 1026
alarm
alarm 1026 is active, owned by amir
Monitors ifEntry.1.1026 every 60 seconds
Taking delta samples, last value was 1712
Rising threshold is 10000, assigned to event # 1054
Falling threshold is 10, assigned to event # 1054
On startup enable rising or_falling alarms
Monitors ifEntry.1.1026 every 60 seconds
Taking delta samples, last value was 1712
Rising threshold is 10000, assigned to event # 1054
Falling threshold is 10, assigned to event # 1054
On startup enable rising or_falling alarms
Show rmon event Command
Use the
show rmon event command to show the parameters of an Event entry
defined by the
rmon event command or using the P130 Device Manager.
The syntax for this command is:
show rmon event [<Event Index>]
show rmon event [<Event Index>]
Example:
P130-N> show rmon event 1054
P130-N> show rmon event 1054
event