Avaya P130 Manuel D’Utilisation

Chapter 5        Avaya P130 CLI - Architecture, Access &Conventions

32

Avaya P130

 

User’s Guide

Establishing a Telnet Connection

Perform the following steps to establish a Telnet connection to the Avaya P130 
Switch Console port for configuration of switch parameters:
1

Connect your station to the network.

2

Verify that you can communicate with the P130 using Ping to the IP of the P130. 
If there is no response using Ping, check the IP address and default gateway of 
both the P130 and the station

.

3

From the Microsoft Windows

®

 taskbar of your PC click Start and then Run (or 

from the DOS prompt of your PC), then start the Telnet session by typing: 
telnet <P130_IP_address> 

4

When you see the “Welcome to P130” menu and are prompted for a Login  
Name, enter the default name

5

When you are prompted for a password, enter the User Level password

 norm in lower case letters (do NOT use uppercase letters). The User level 

prompt will appear when you have established communications with the P130.

Note:  When terminating a Telnet session established from one module to another, 
use the Exit command to return to the original module. 

To enter the CLI, enter your username and password. Your access level is indicated 
in the prompt as follows: 
The User level prompt is shown below: 
P130-N> 
The Privileged level prompt is shown below: 
P130-N# 
The Supervisor level prompt is shown below: 
P130-N(super)# 

Conventions Used

The following conventions are used in this chapter to convey instructions and 
information:
•

Mandatory keywords are in boldface.

•

Variables that you supply are in pointed brackets <>.

•

Optional keywords are in square brackets [].

•

Alternative but mandatory keywords are grouped in braces {} and separated by