Avaya P330-ML-ML Manuel D’Utilisation
Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide
131
show boot bank
User level: privileged, supervisor.
L This command is not supported by the P333R and P333R-LB switches.
Use the show boot bank command to display the software bank from which the
switch will boot at the next boot process.
You must issue this command separately for each switch in the stack using the
session
L This command is not supported by the P333R and P333R-LB switches.
Use the show boot bank command to display the software bank from which the
switch will boot at the next boot process.
You must issue this command separately for each switch in the stack using the
session
command.
L If you wish to run this command on a switch other than the stack master, you
need to open a session to the relevant switch.
The syntax for this command is:
show boot bank
Example:
show cam
User level: user, privileged, supervisor
Use the show cam command to either display the module and port number where
a specific MAC address was learned, or the MAC addresses learned on a specific
module and port.
L MACs associated with LAGs appear under the LAG ID, not under the LAG
Use the show cam command to either display the module and port number where
a specific MAC address was learned, or the MAC addresses learned on a specific
module and port.
L MACs associated with LAGs appear under the LAG ID, not under the LAG
port.
The syntax for this command is:
show cam [module[/port]]
P330-N>show boot bank
Boot bank set to bank-a
module
(Optional)
(Optional)
Number of the switch. If you do not specify a number, all
switches in the stack are shown.
switches in the stack are shown.
port
(Optional)
(Optional)
Number of the port on the module. If you do not specify a
number, all ports on the specified switch are shown.
number, all ports on the specified switch are shown.