Avaya P330-ML-ML Manuel D’Utilisation
Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide
201
snmp-server enable
User level: supervisor
Use the snmp-server command to enable SNMP Access to the switch.
Use the snmp-server command to enable SNMP Access to the switch.
The syntax for this command is:
snmp-server enable [volatile]
Example:
snmp-server enable notifications
User level: supervisor
Use the snmp-server enable notifications command to enable sending all
Simple Network Management Protocol (SNMP) notifications (traps and informs).
Use the snmp-server enable notifications command to enable sending all
Simple Network Management Protocol (SNMP) notifications (traps and informs).
The syntax for this command is:
snmp-server enable notifications
Example:
snmp-server engineID
User level: supervisor
Use the snmp-server engineID command to change the SNMP Engine ID. Only
the default user can run this command.
Use the snmp-server engineID command to change the SNMP Engine ID. Only
the default user can run this command.
volatile
(Optional)
(Optional)
By default the activation of the snmp-server command is
permanent and automatically stored in the non-volatile
memory. The SNMP server is automatically launched after all
restarts. If the volatile parameter is provided, then the SNMP
service runs only until the stack is reset.
permanent and automatically stored in the non-volatile
memory. The SNMP server is automatically launched after all
restarts. If the volatile parameter is provided, then the SNMP
service runs only until the stack is reset.
P330-N>snmp-server enable
Done!
P330-N>snmp-server enable notifications
Done!