Avaya 882 Manuel D’Utilisation

21-16

User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1

Chapter 21

3. In the Enable State field, select Enable or Disable:

■

Enable—Enables syslog reporting to the IP addresses that you enter
in the Syslog Collector’s IP Addresses fields.

■

Disable—Disables syslog reporting. Syslog is disabled by default.

4. In the Syslog Collector’s IP Addresses fields, enter the IP addresses of

the remote syslog servers. You can specify a maximum of three syslog
servers.

5. In the Severity field, select a severity level. See

Table 21-6

for more

information about each severity level. The default setting for this field is
error.

The switch logs error messages of the severity that you select and of all
higher severities.

6. Click Apply.

CLI Command

Use the following CLI commands to configure syslog event reporting:

■

To enable or disable syslog event reporting,

(configure)#

set

syslog {enable | disable}

■

To configure which events are logged,

(configure)#

set syslog

facility {start | system | config | temp | resource | fan |
service_port | user _port | power | bridge_stat | switch_fabric |
ospf | rip | ldap | appletalk | auth_failure | redundant_cpu |
dvmrp | cli | snmp | unknown_mac | vrrp | login_status | acl_log |
ssl_ssh | all}

■

To set IP addresses of remote syslog servers,

(configure)#

set

syslog server_ip <ip_address>

■

To set a severity level,

(configure)#

set syslog severity

{emergency | alert | error | warning | normal | informational}

■

To view the current configuration for syslog even reporting,

show syslog config

■

To view events in the syslog buffer,

show syslog buffer