Avaya P880 Manuel D’Utilisation
29
610-0184-095
June 14, 2001
Workaround:
Either:
■
Disable auto-negotiation
■
Use a patch cable that is longer that 5 meters
■
Enter the following Enhanced CLI command in legacy mode:
> port set NationalPhyMode <slot>.<port> enable
The factory default for the National Phy Mode is Enable.
Checksum Error Message
Problem:
The following checksum error displays after you upgrade from 4.3.x
code to v5.x code:
code to v5.x code:
Bad file header compressed checksum...transfer cancelled.
Workaround:
Ignore the checksum error and reboot the switch to upgrade the
software.
software.
CajunView v3.0
CajunView v3.0 does not support 80-series hardware. CajunView
v4.0 will support 50-series hardware and 80-series hardware on
Cajun switch software code version 5.1 and later.
v4.0 will support 50-series hardware and 80-series hardware on
Cajun switch software code version 5.1 and later.
CPU Synchronization
Problem:
If you attempt to synchronize the active supervisor and redundant
supervisor while the supervisor is being heavily used, TFTP transfers
from the active supervisor to the redundant supervisor may time out
and fail.
supervisor while the supervisor is being heavily used, TFTP transfers
from the active supervisor to the redundant supervisor may time out
and fail.
Workaround:
Repeat the synchronization when use of the supervisor has
decreased.
decreased.
Legacy CLI
Problem:
The Legacy CLI setup command does not save information that you
enter.
enter.