HP (Hewlett-Packard) 2610 Manuel D’Utilisation
3-2
Configuring the Switch
Recommended Minimal Configuration
Recommended Minimal Configuration
Co
nf
igur
in
g t
he Sw
it
c
h
Using the Console Setup Screen
The quickest and easiest way to minimally configure the switch for
management and password protection in your network is to use a direct
console connection to the switch, start a console session, and access the
Switch Setup screen.
management and password protection in your network is to use a direct
console connection to the switch, start a console session, and access the
Switch Setup screen.
1.
Using the method described in the preceding section, connect a terminal
device to the switch and display the switch console command line
interface (CLI) prompt (the default display).
device to the switch and display the switch console command line
interface (CLI) prompt (the default display).
The CLI prompt appears, for example:
ProCurve#
2.
At the prompt, enter the
setup command to display the Switch Setup
screen. The following illustration shows the Setup screen with the default
settings.
settings.
Figure 3-1. Example console setup screen
3.
Use the
[Tab]
key to select the
Manager Password field and enter a manager
password of up to 16 printable ASCII characters.
4.
[Tab]
to the
IP Config (DHCP/Bootp) field and use the Space bar to select the
Manual option.
5.
[Tab]
to the
IP Address field and enter the IP address that is compatible with
your network.
6.
[Tab]
to the
Subnet Mask field and enter the subnet mask used for your
network.
7.
Press [
Enter]
, then
[S]
(for
Save).
2007
2610-48
u