Brocade Communications Systems IPMC5000PEF Manuel D’Utilisation

 

   System-max limit for SG entries: 6144

Syntax: show ipv6 pim [ all-vrf | [ vrf vrf-name ] ] hw-resource

The vrf parameter allows you to display hardware resource information for the VRF instance identified
by the vrf-name variable.

The following table displays the output from the show ipv6 pim all-vrf hw-resource command.

Output from the show ipv6 pim all-vrf hw-resource command 

VRF

Name of the VRF.

Usage

Number of allocated SG entries in this VRF.

Fail

Number of failures while allocating SG entries in this VRF (due to system-max
limit).

Total usage

Total number of SG entries in the system (All-VRFs).

System-max limit for SG entries Configured system limit using the pim6-hw-mcache command.

Displaying PIM traffic statistics

To display IPv6 PIM traffic statistics, enter the show ipv6 pim traffic command at any CLI level.

device# show ipv6 pim traffic

Port    HELLO     JOIN-PRUNE  ASSERT    REGISTER  REGISTER  BOOTSTRAP CAND. RP  Err

                                      GRAFT(DM) STOP(SM)  MSGS (SM) ADV. (SM)

-------+---------+-----------+---------+---------+---------+---------+---------+---

       Rx        Rx          Rx        Rx        Rx        Rx        Rx        Rx

------+---------+-----------+---------+---------+---------+---------+---------+---

v170    0         0           0         0         0         0         0         0

v501    0         0           0         0         0         0         0         0

v503    3302      2524        0         0         0         0         0         0

Port    HELLO     JOIN-PRUNE  ASSERT    REGISTER  REGISTER  BOOTSTRAP CAND. RP  Err

                                      GRAFT(DM) STOP(SM)  MSGS (SM) ADV. (SM)

-------+---------+-----------+---------+---------+---------+---------+---------+---

       Tx        Tx          Tx        Tx        Tx        Tx        Tx

------+---------+-----------+---------+---------+---------+---------+---------+---

v170    3576      0           0         0         0         0         0

v501    1456      0           0         0         0         0         0

v503    1456      1314        0         0         0         2         0

Syntax: show ipv6 pim [ vrf vrf-name ] traffic

The vrf parameter allows you to display IPv6 traffic statistics for the VRF instance identified by the vrf-
name variable.

The following table displays the output from the show ipv6 pim traffic command.

Output from the show ipv6 pim traffic command

Port

The port or virtual interface on which the IPv6 PIM interface is configured.

Hello

The number of IPv6 PIM Hello messages sent or received on the interface.

Displaying PIM traffic statistics