Belkin F1DP108Gea Manuel D’Utilisation

58

Now that you have connected your console and servers to the Switch, 
it is ready for use. You can select connected servers by using either the 
front-panel port selectors, the On-Screen Display (OSD), or hot-key commands 
through the console keyboard. It takes approximately 1–2 seconds for the video 
signal to refresh after switching servers. Re-synchronization of the mouse and 
keyboard signals also occurs. This is normal operation and ensures that proper 
synchronization is established between the console and the connected servers.

Switch to the next or previous port with simple keyboard hot-key sequences 
using the Scroll Lock key and either the up or down arrow keys. To send 
commands to the Switch, the Scroll Lock key must be pressed twice within two 
seconds. The Switch will beep, confirming that it is in hot-key mode. Next, press 
the up arrow key and the Switch will switch to the next port. Press the down 
arrow key to switch to the previous port.

With a single-switch configuration (no daisy-chained KVM switches), you can 
switch directly to any port by entering the 2-digit number of the port you wish to 
access. For example, if you press “Scroll Lock”, “Scroll Lock”, “02”, the Switch 
will switch to the server on port 2 located on BANK 00.

Using the Switch from a Local Console

Switch to next active port, “Up” arrow.

Switch to previous active port, 

“Down” arrow

Switch to BANK 00, Port 2 (02)