Moxa Technologies EDS-405A Manuel D’Utilisation

 

NOTE 

The proprietary “Turbo Ring” protocol (recovery time < 300 ms) was developed by Moxa in 
2003 to provide better network reliability and faster recovery time for redundant ring topologies. 
The “Turbo Ring V2” protocol (recovery time < 20 ms), which was released in 2007, supports 
additional redundant ring architectures. 

In this manual, we use the terminology “Turbo Ring” ring and “Turbo Ring V2” ring to 
differentiate between rings configured for one or the other of these protocols. 

For a detailed description of “Turbo Ring” and “Turbo Ring V2,” please refer to the Using 
Communication Redundancy section later in this chapter. 

 

Setting 

Factory Default 

Enable the Turbo 
Ring DIP 
Switches 

The four DIP switches are enabled when the 
“Disable the Turbo Ring DIP Switch” box is 
not checked. 

Disable the Turbo 
Ring DIP 
Switches 

The four DIP switches are disabled when the 
“Disable the Turbo Ring DIP Switch” box is 
checked. 

Not checked (i.e., the 
Turbo Ring DIP Switches 
are enabled by default) 

Setting 

Factory Default 

Set DIP switch as 
Turbo Ring 

Select this option to enable the Turbo Ring DIP 
switches to configure the EDS for a “Turbo 
Ring” ring. 

This is the default if you do 
NOT reset the switch to 
factory default settings 
(provided you upgraded the 
firmware for Turbo Ring 
V2). 

Set DIP switch as 
Turbo Ring V2 

Select this option to enable the Turbo Ring DIP 
switches to configure the EDS for a “Turbo 
Ring V2” ring. 

This is the default if you 
DO reset the switch to 
factory default settings 
(provided you upgraded the 
firmware for Turbo Ring 
V2).