Acer A100 Manuel D’Utilisation
67
• If you spill liquid on your device, switch it off immediately, unplug the
AC adapter. Do not attempt to service your device yourself, as opening
or removing covers may expose you to dangerous voltage or other risks.
Refer all servicing to qualified service personnel.
or removing covers may expose you to dangerous voltage or other risks.
Refer all servicing to qualified service personnel.
Unplug your device from the wall outlet and refer servicing to qualified service
personnel when:
• The power cord or plug is damaged, cut or frayed.
• Liquid was spilled into the product.
• The product was exposed to rain or water.
• The product has been dropped or the case has been damaged.
• The product exhibits a distinct change in performance, indicating a need
personnel when:
• The power cord or plug is damaged, cut or frayed.
• Liquid was spilled into the product.
• The product was exposed to rain or water.
• The product has been dropped or the case has been damaged.
• The product exhibits a distinct change in performance, indicating a need
for service.
Note: Adjust only those controls that are covered by the operating
instructions, since improper adjustment of other controls may result in
damage and will often require extensive work by a qualified technician to
restore the product to normal condition.
instructions, since improper adjustment of other controls may result in
damage and will often require extensive work by a qualified technician to
restore the product to normal condition.
Battery information
This product uses a Lithium-ion battery. Do not use it in a humid, wet and/or
corrosive environment. Do not put, store or leave your product in or near a heat
source, in a high temperature location, in strong direct sunlight, in a microwave
oven or in a pressurized container, and do not expose it to temperatures over
60 °C (140 °F). Failure to follow these guidelines may cause the battery to leak
acid, become hot, explode or ignite and cause injury and/or damage. Do not
pierce, open or disassemble the battery. If the battery leaks and you come into
contact with the leaked fluids, rinse thoroughly with water and seek medical
attention immediately. For safety reasons, and to prolong the lifetime of the
battery, charging will not occur at low (below 0 °C/32 °F) or high (over 40 °C/104
°F) temperatures.
The full performance of a new battery is achieved only after two or three
complete charge and discharge cycles. The battery can be charged and
discharged many times, but it will eventually wear out. When normal use and
standby times are noticeably shorter than normal, contact your reseller. Use
only manufacturer approved batteries, and recharge your battery only with
manufacturer approved chargers designated for this device.
Unplug the charger from the electrical plug and the device when not in use. If
left unused, a fully charged battery will lose its charge over time. If the battery
is completely discharged, it may take a few minutes before the charging
indicator appears on the display or before the device can be used.
Use the battery only for its intended purpose. Never use any charger or battery
that is damaged.
Do not short-circuit the batteries under any condition. Accidental short-
circuiting can occur when a metallic object such as a coin, clip, or pen causes
direct connection of the positive (+) and negative (-) terminals of the battery.
corrosive environment. Do not put, store or leave your product in or near a heat
source, in a high temperature location, in strong direct sunlight, in a microwave
oven or in a pressurized container, and do not expose it to temperatures over
60 °C (140 °F). Failure to follow these guidelines may cause the battery to leak
acid, become hot, explode or ignite and cause injury and/or damage. Do not
pierce, open or disassemble the battery. If the battery leaks and you come into
contact with the leaked fluids, rinse thoroughly with water and seek medical
attention immediately. For safety reasons, and to prolong the lifetime of the
battery, charging will not occur at low (below 0 °C/32 °F) or high (over 40 °C/104
°F) temperatures.
The full performance of a new battery is achieved only after two or three
complete charge and discharge cycles. The battery can be charged and
discharged many times, but it will eventually wear out. When normal use and
standby times are noticeably shorter than normal, contact your reseller. Use
only manufacturer approved batteries, and recharge your battery only with
manufacturer approved chargers designated for this device.
Unplug the charger from the electrical plug and the device when not in use. If
left unused, a fully charged battery will lose its charge over time. If the battery
is completely discharged, it may take a few minutes before the charging
indicator appears on the display or before the device can be used.
Use the battery only for its intended purpose. Never use any charger or battery
that is damaged.
Do not short-circuit the batteries under any condition. Accidental short-
circuiting can occur when a metallic object such as a coin, clip, or pen causes
direct connection of the positive (+) and negative (-) terminals of the battery.