Acer G901 Manuel D’Utilisation
3 Hardware configuration
60
Memory
This section includes instructions for removing and installing DIMMs on
the memory board.
the memory board.
DIMM sequence
Load the DIMMs in the following order:
•
Bank 1: DIMMs #1, 2, 3, and 4
•
Bank 2: DIMMs #5, 6, 7, and 8
•
Bank 3: DIMMs #9, 10, 11, and 12
Always fill banks completely. Partially filled banks are ignored by the
system.
system.
To install DIMMs
Caution! Use extreme care when installing a DIMM. Applying
too much pressure can damage the socket. Keyed DIMMs insert
only one way.
too much pressure can damage the socket. Keyed DIMMs insert
only one way.
1
Remove the memory board (refer to page 52), and place the board
component-side up on a nonconductive, static-free surface.
component-side up on a nonconductive, static-free surface.
2
Holding the DIMM only by its edges, remove it from its antistatic
package.
package.
3
Open the plastic ejector levers (Figure 25, A) at each end of the
DIMM socket on the memory board .
DIMM socket on the memory board .
Figure 24 - Correct order in loading DIMMs
BB!H:11!vh!.!FO/cppl!!Qbhf!71!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN