Intel 5800/120Ld Manuel D’Utilisation

6.  Remove the screw securing the filler panel removed in the previous step to

the right device rail. Save the right device rail. See Figure 4-28.

7.  Remove the device from its protective wrapper and place it on an antistatic

surface. Record the drive model and serial number in the equipment log.

8.  Set any drive jumpers or switches before you install the drive. See the

documentation that comes with the device for jumper or switch information.

If the drive comes with drive rails, do not use

them. Remove any rails already attached.

9.  Position the right device rail along the right side of the device so that the

four holes in the device rail match the four holes located in the side of the
device. Attach the right device rail to the device with four screws as shown
in Figure 4-29.