Manualsbrain.com
  1. Manuels
  2. Marques
  3. Adtran
  4. MP-118
  5. Manuel D’Utilisation

Adtran MP-118 Manuel D’Utilisation

Télécharger
Page de 44
Quick Installation Guide 
 6. Troubleshooting 
Version 5.0 
41 
September 2007 
¾
  To configure the Syslog parameters, take these 7 steps: 
1. 
Open the ‘Management Settings’ screen (Advanced Configuration menu > Management 
Settings
); the ‘Management Settings’ screen is displayed. 
Figure  6-1: Management Settings Screen 
 
2. 
In the 'Syslog Server IP Address' field, enter the Syslog's IP address. Note that the Syslog 
server's IP address must correspond to the network environment in which the Syslog server 
is installed. 
3. 
In the 'Syslog Server Port' field, enter the UDP port number (default port is 514).  
4. 
From the 'Enable Syslog' drop-down list, enable the Syslog feature by selecting 'Enable'. 
5. 
In the 'Activity Types to Report' group, select the Web operations that you want logged to the 
Syslog server. 
6. 
To define the messages based on severity level that you want sent to the Syslog server, 
open the ‘General Parameters’ screen (Protocol Management menu > Advanced 
Parameters
 > General Parameters), and then from the 'Debug Level' drop-down list, select 
'5' (i.e., all reports with severity level 5 are sent to the Syslog server). 
7. 
To enable additional call information sent to the Syslog, in the 'CDR Report Level' drop-down 
list, select 'End Call' 
 
 
3
 
2
 
4
 
5