Toshiba Satellite R10 Manuel D’Utilisation
4 Replacement Procedures
4.8 Bottom cover assembly
Satellite R10 Maintenance Manual (960 -509)
4-21
4.8 Bottom cover assembly
Removing the bottom cover assembly
The following describes the procedure for removing the bottom cover assembly. (See
Figure 4-10 and 4-11.)
Figure 4-10 and 4-11.)
1. Disconnect the touch pad cable from the connector CN3201 on the system board.
Figure 4-10 Removing the touch pad cable
2. Close the display and turn the computer upside down.
3. Remove the following screws securing the bottom cover assembly.
?
M2.0x6.0B
FLAT BIND screw
x19 (Described as "6" in figure)
?
M2.0x3.0B
S-THIN FLAT BIND screw x2 (Described as "3" in figure)
4. Pull up to remove the bottom cover assembly from the computer.
CN3201
Touch pad cable