ETA Systems ETA-PD8 Manuel D’Utilisation

Specifications are subject to change without notice.

1601 Jack McKay Blvd. • Ennis, Texas 75119  U.S.A.

Telephone: 800-321-6699 • Fax: 800-996-3821

4.  Wrap the zip tie around the power cord as shown in Figure 4.

5.  Feed the end of the zip tie through the retainer and pull tightly  
 

to secure. 

Note: Some adjustment of the retainer may be   

 

needed in order to properly align it as shown in Figure 6.

6.  Cut the excess zip tie off as shown in Figure 7.

Your ETA Systems product comes with an AC Mains Power Cord Retainer System. This system prevents the power 
cord from being removed without the use of a screwdriver. Follow these steps for installation.

Note: Installation of this product must be done by a certified electrician for a permanently connected apparatus provided 
neither with an all-pole mains switch nor an all-pole circuit breaker. A readily accessible disconnect device shall be 
incorporated in the building installation power wiring. The installation shall be carried out in accordance with all applicable 
installation rules in accordance with all applicable federal, state, and local laws, regulations, safety codes and ordinances. 

1.  Locate the 6/32 screw, retainer clip, and zip tie. 

2.  Locate the AC wall outlet that will be used to power the  
 

Atlas Power product. Remove the center screw securing the  

 

cover plate  to the AC outlet.

3.  Place the screw through the retainer clip and insert into the  
 

cover plate making sure to securely tighten. Inset the zip tie  

 

through the retainer clip slots as shown in Figure 3.