ETA Systems eta-ecm2063 Manuel D’Utilisation

Specifications are subject to change without notice.

1601 Jack McKay Blvd. • Ennis, Texas 75119  U.S.A.

Telephone: 800-321-6699 • Fax: 800-996-3821

Below are four configurations for load distribution. After following the wiring diagram place the label of the Internal Wiring Configuration
on the panel box. 

Note: All electrical wiring must be done by a certified electrician. Follow the steps below for wiring the AC mains.

Accessing the Internal Wiring 
 

1.  Locate the Control Input Panel.

 

2.  Remove the four screws. (See diagram below)

3.  Remove the Control Input Panel. Note: A ribbon cable is attached. Carefully lay panel aside leaving the cable attached.  

 

 

Do not pull on cable or damage may occur. 

 

4.  Select the load configuration from the wiring diagram that applies on the following pages.

 

5.  Carefully place the input panel back onto the raceway paying close attention to the ribbon cable to ensure that it does not  

 

 

become twisted or pinched between the panel and the chassis.

 

6.  Secure the Control Input Panel

 

7.  Select the proper Internal Wiring Label and place it on the front panel.

 36.84 

 3.26 

 5.25 

 2.59