APC AP8861 Manuel D’Utilisation

•   A  Stat field reports the Rack PDU status.

Stat : P+ N4 N6

Note: If P+ is not displayed, contact APC support staff.

At the command line interface, use commands to configure the Rack PDU. To use a command, type the 

command and press 

ENTER

. Commands and arguments are valid in lowercase, uppercase, or mixed case. 

Options are case-sensitive.

While using the command line interface, you can also do the following:

•  Type 

?

 and press 

ENTER

 to view a list of available commands, based on your account type.

•  To obtain information about the purpose and syntax of a specified command, type the command, a 

space, and 

?

 or the word 

help

. For example, to view RADIUS configuration options, type:

radius ?

or 

radius help

•  Press the 

UP

 arrow key to view the command that was entered most recently in the session. Use 

the 

UP

 and 

DOWN

 arrow keys to scroll through a list of up to ten previous commands.

•  Type at least one letter of a command and press the 

TAB

 key to scroll through a list of valid 

commands that match the text you typed in the command line.

•  Type 

exit

 or 

quit

 to close the connection to the command line interface.

P+ 

The APC operating system (AOS) is functioning properly.

N+ N+

N4+ 

N6+

The network is functioning properly.

N? N6?

N4? 

N6?

A BOOTP request cycle is in progress.

N– N6-

N4- 

N6-

The Rack PDU failed to connect to the network.

N! N6!

N4! 

N6!

Another device is using the Rack PDU IP address.

* The N4 and N6 values can be different from one another: you could, for example, have 
N4- N6+.

A+

The application is functioning properly.

A–

The application has a bad checksum.

A?

The application is initializing.

A!

The application is not compatible with the AOS.