Metrologic Instruments MS5100 Manuel D’Utilisation

 

 

11

I

NSTALLATION

 

 

 

1.  Turn off the host system. 

2.  Connect the 10-pin RJ45 male 

connector of the USB cable into the 
jack on the Eclipse.  You will hear a 
‘click’ when the connection is made. 

3.  Connect the other end of the USB 

cable to the host USB port. 

4.  Turn on the host system. 

 

 

 
 
 
 
 

As a default, the MS5145-38 leaves the factory with USB Keyboard 
Emulation Mode enabled.   
 
For information on configuring the MS5145-38 for USB Serial Emulation  
Mode, please refer to the USB section of the MetroSelect Single-Line 
Configuration Guide (00-02544X). 

 

Plugging the scanner into a port on the host system does not guarantee 
that scanned information will be communicated properly to the host 
system.  All Eclipse’s are shipped already configured with a set of 
factory defaults. Please refer to the MetroSelect Single-Line 
Configuration Guide or MetroSet2’s help files for instructions on 
changing the scanner’s factory default configuration.  The scanner and 
host system must use the same communication protocols.