Fujitsu M3097G+ Manuel D’Utilisation
4 – 2
4.2
Reading a Document in Flatbed Mode
This section explains how to read a document placed on the document
bed.
bed.
CAUTION
!
High luminance: Do not look directly at the light source during
read operation. Keep the document cover in
place.
place.
4.2.1
Reading a standard-size document
If the size of the document is smaller than the document bed, read the
document using the following procedure:
document using the following procedure:
1
Open the document cover.
2
Place the document face down on the document board. Correct
any curled or folded parts of the document.
any curled or folded parts of the document.
3
Position the long side (in landscape mode) or the short side (in
portrait mode) of the document to the left side of the document
bed.
portrait mode) of the document to the left side of the document
bed.
4
Position the left top of the document to the reference mark. If the
document is not placed correctly, reading cannot be done cor-
rectly.
document is not placed correctly, reading cannot be done cor-
rectly.
5
Close the document cover slowly. If the document cover is
closed too quickly, the document may move.
closed too quickly, the document may move.
6
For M3097E+, select a reading mode from the operator panel and
start the read operation. For the M3097G+, the scanner starts the
read operation by a command from the host system. Do not press
on or open the document cover during the read operation.
start the read operation. For the M3097G+, the scanner starts the
read operation by a command from the host system. Do not press
on or open the document cover during the read operation.
7
After reading, open the document cover to remove the document.