Multiquip MC-42S Manuel D’Utilisation

DO NOT attempt to operate the mixer until
the Safety, General Information and

Inspection sections have been read and
understood.

1. Before starting,  make sure mixer is positioned on a secure

flat surface to prevent rolling.

2. Use an extension cord (see Table 5) of adequate current

carrying capacity, insert  the electric motor's power plug  into
one end of the extension cord.

3.

NEVER! use a worn or frayed extension cord.

4.

NEVER! operate mixer with V-belt cover removed.

NEVER! touch the power cord (Figure 15)
with 

wet hands or while standing in water

when it is connected to a power source. The
possibly exists of electrical shock
(electrocution) even death. 

NEVER! spray

water directly on the electric motor.

ALWAYS read the label on the electric motor
before applying power. The label will indicate
the correct power requirements for the motor.
Remember the use of an incorrect input
voltage will severely damage the electric
motor.

To prevent personnel from tripping over
the extension cord, position the

extension cord so that it lays flat and is
not curled underneath the mixer.

1.

Set the electric motor's ON/OFF switch  (Figure 17) to the
ON position.

5. Plug the other end of the extension cord into a 120 VAC

G.F.C.I. protected  receptacle.  Remember the power require-
ments for this electric motor  is 120 VAC, 60 Hz.  The use of
any other input voltage will severely damage the motor.

ALWAYS read the label on the electric motor
before applying power. The label will indicate
the proper power requirements for the motor.
Remember the use of any other input voltage

will severely damage the motor.

To prevent tripping (Figure 16) of both the
mixer and personnel, position the extension
cord so that it lays flat and is not curled

underneath the mixer.