3com 09-1324-000 Manuel D’Utilisation

6 Enter a routing protocol. 

For example, enable RIP using:

SETDefault !<port> -RIPIP CONTrol = (Listen, Talk)

7 Confirm your configuration by verifying that the NETBuilder II bridge/router can 

reach the network management station using:

PING <IP address>

where <IP address> is the IP address of the network management station. 

To copy the software from the network management station to the NETBuilder II 
bridge/router using TFTP, follow these steps:

1 If you have not already done so, insert a blank flash memory card in drive A. 

Refer to the software release notes for a list of flash memory cards that can be used 
with the CEC 20 module.

For instructions on installing the flash memory drive and inserting a flash memory 
card, refer to the NETBuilder II Flash Memory Drive Installation Guide. 

2 Format the blank flash memory card by entering:

Type Y at the formatting confirmation message.

3 Create a destination directory on the flash memory card.

4 Copy the NETBuilder II software images from the network management default 

directory (tftpboot) into the /primary directory on the flash memory card. 

For example:

where 192.65.74.10 is the IP address of the network management station.

The software images to copy to the NETBuilder II bridge/router may include the 
following files:

■

boot.29k – Image file that boots the CEC20 module

■

ccsmacro – File that contains predefined user macros

■

sys – File that is used during the upgrade process to determine the source and 
target software versions

■

mp6e.29k – Image file that boots the multiprocessor Ethernet module

■

mpatm.29k – Image file that boots the multiprocessor ATM module

To change your bridge/router primary boot source, refer to Chapter 5.