3com 09-1324-000 Manuel D’Utilisation

You may set up the Simple Network Management Protocol (SNMP) to allow 
network management of the bridge/router. For information on this service, refer 
to “Setting Up the Simple Network Management Protocol” on page 6-22.

Refer to Chapter 6 to configure basic settings.

To set other boot options, refer to the SysconF appendix in Reference for 
NETBuilder Family Software.

If your boot source is reachable through a token ring port, you are prompted 
to configure the following field:

■

Token Ring Speed
This setting must correspond to the token ring line setting (the default is 
4 Mbps).

■

Token Ring Baud Rate
Make sure the setting of this field matches that of your token ring line.

Boot Protocol

Make sure the Boot Protocol is set to TFTP.

If you are configuring your bridge/router to use TFTP only, set the Address 
Discovery Protocol to Local Configured Addresses.

If you are configuring your bridge/router to use TFTP and BOOTP, set the 
Address Discovery Protocol to BOOTP.

Boot Sources

Make sure the Boot Sources are set to Primary and Secondary.

MAC Address

Make sure this parameter is set to the CEC 20 MAC address.

ARP Format

If your boot source is reachable through a token ring port, make sure that the 
setting of this parameter agrees with the Address Resolution Protocol (ARP) 
format used on your token ring network: noncanonical.

Table A-1   Additional TFTP Primary Boot Source Parameters (continued)