NuTone HS-93 Fascicule

Used with Heat–Vent–Light
Combination.
1. Install a double–gang box.
2. Refer to Figure 1. Run power wiring

from fuse box or circuit breaker and
wiring from heat–vent–light wires to
outlet box.

3. Secure all wires to outlet box with an

approved box connector.

4. Dress all leads, leaving

approximately 1/2" of bare wire for
making connections.

5. Refer to Figure 1. Make wire

connections. Observe cover plate
markings (Heat–Vent–Light) when
making connections. Make sure that
the switch and the unit it controls are
properly grounded.

6. Refer to Figure 2. Using two supplied screws, secure switch bracket

assembly to outlet box adapter plate.

7. Position wall plate over switch assembly and secure with supplied screws.

®

Used with Heat–Vent–Light
Combination.
1. Install a double–gang box.
2. Refer to Figure 1. Run power wiring

from fuse box or circuit breaker and
wiring from heat–vent–light wires to
outlet box.

3. Secure all wires to outlet box with an

approved box connector.

4. Dress all leads, leaving

approximately 1/2" of bare wire for
making connections.

5. Refer to Figure 1. Make wire

connections. Observe cover plate
markings (Heat–Vent–Light) when
making connections. Make sure that
the switch and the unit it controls are
properly grounded.

6. Refer to Figure 2. Using two supplied screws, secure switch bracket

assembly to outlet box adapter plate.

7. Position wall plate over switch assembly and secure with supplied screws.

®