Smeg SA561X-9 Manuel D’Utilisation

48

The identification plate bearing the technical data, serial number and brand
name is visibly positioned on the appliance.
Do not remove this plate for any reason.

The appliance must be connected to earth in compliance with electrical system
safety regulations.

If a fixed connection is being used, fit the power line with an omnipolar circuit-
breaker in accordance with the installation rules, located in a position which is
easy to reach and near the appliance.

If a plug and socket connection is being used, make sure that the plug and
socket are compatible. Avoid use of adapters and shunts as these could cause
overheating and a risk of burns.

Operation at 220-240 V~: use a H05V2V2-F type

three-core cable (3 x 1.5 mm

2

).

The end to be connected to the appliance must
have an earth wire (yellow-green) at least 20 mm longer than the others.

Should the supply cable need replacing,
remove the back guard by unscrewing the
screws to gain access to the terminal.

Replace the cable. The cable cross-
section must be no less than 1.5 mm² (3 x
1.5) (see 10.1 Electrical connection).
Make sure that the cables (for the oven or
any hob) follow the best route in order to
avoid any contact with the oven.

WARNING: The tightening torque of the screws of the terminal supply wires
must be 1.5 - 2 Nm.